Description
Concentrated liquid iodophor-based disinfectant for the
disinfection of animal housing & associated equipment as part
of a biosecurity programme to aid in the prevention of
transmission of disease-causing microorganisms.
CONTAINS IODINE 2.84% W/W (ACTIVE), SULPHURIC ACID, PHOSPHORIC ACID.
Directions for use
PREPARATION FOR DISINFECTION – ANIMAL HOUSING & VEHICLES: Remove all
animals. Remove all portable equipment, litter and manure. Clean thoroughly with a suitable
detergent, washing away to drain. Rinse surfaces thoroughly with water and allow to dry if possible.
Ensure application equipment is clean before disinfection. Decant or dispense (using dispensing
equipment) the concentrated product and dilute with water at 1:100. Application rate: 300 mL/m²
disinfectant solution.
ANIMAL HOUSING – SURFACE & EQUIPMENT: Prepare surfaces as above. Spray or foam the
disinfectant solution making sure surfaces are thoroughly wetted and leave to dry for 30 minutes,
porous surfaces should be allowed to dry for a minimum of 4 hours.
ANIMAL HOUSING – EQUIPMENT IMMERSION: Fill a clean container with the disinfectant
solution and place equipment (e.g. buckets, cages, hatchery trays, drinkers, crates) in the solution,
leave for at least 30 minutes before removing and allowing equipment to drain and dry.
VEHICLE DISINFECTION: Prepare the vehicle as above. First, apply the disinfectant solution to
the outside of the vehicle starting at the top and working down, including wheel arches, tyres,
mudguards and underside of the vehicle. Thereafter, spray on the inside of the vehicle, starting at the
top and working down, ensuring that all surfaces including the floor are covered. Minimum contact
time 30 minutes before rinsing.
DISINFECTION OF FISH FARM EQUIPMENT: Equipment should be cleaned as above before
disinfection. Prepare the product as above. Fill a clean container with the disinfectant solution and
place equipment (e.g. buckets, trays, fish nets, crates) in the solution, leave for at least 30 minutes
before removing, drain, rinse the equipment with clean potable water and allow to dry. For larger
pieces of equipment such as fish holding tanks, fill cleaned containers with disinfection solution, leave
for a minimum of 30 minutes, drain, rinse with clean water and allow to dry.
WHEEL & BOOT DISINFECTION: Wheels and boots should be cleaned with a brush/power
wash to remove organic material. Prepare the product as above. A two-minute contact time is
required before moving from one area to another. Empty, clean and refill wheel baths when heavily
soiled or after 72 hours, up to a maximum volume of 400 L. Footbaths must be covered / kept indoors
in order to prevent dilution by rain.
AFTER DISINFECTION: After disinfection, empty and clean application equipment by rinsing
with water. Used solutions can be flushed to the municipal sewer or disposed to the manure deposit
depending on local requirements. Avoid release to an on-site waste-water treatment plant.
This disinfectant product has been approved for disinfection of inanimate surfaces where an approved product is required to
be used under the control legislation for the following specific disease(s) orders;
•Foot-and-mouth disease at the dilution rate of one part of this preparation plus 550 parts of water.
• Swine vesicular disease at the dilution rate of one part of this preparation plus 100 parts of water.
• Poultry diseases including avian influenza, influenza of avian origin in mammals,
Newcastle disease, paramyxovirus at a dilution rate of one part of this preparation plus 65 parts of water.
• Tuberculosis disease at a dilution rate of one part of this preparation plus 14 parts of water.
This disinfectant product has also been approved at a dilution rate of 1 part of this preparation plus 49 parts water for disinfection of inanimate surfaces where General Orders
require the use of an approved disinfectant. This Approval is
granted under the Disease of Animals (Approved Disinfectants) Orders by the Secretary of State for Environment, Food and Rural Affairs in England, Scottish Ministers in Scotland and Welsh Ministers in Wales. For confirmation of continuing approval refer to the Defra list of approved disinfectants at
http://disinfectants.defra.gov.uk.
FOR PROFESSIONAL USE ONLY
PRECAUTIONS: • Wear protective chemical resistant gloves (EN 374), a protective coverall (at least type 4, EN 14605) and eye
protection during handling of the product. • Keep only in the original container in a cool, well-ventilated place. • Store away from
oxidising materials. • Avoid exposure to high temperatures or direct sunlight. • Cover feed and water troughs during application.
MOST IMPORTANT SYMPTOMS & EFFECTS: INHALATION: Irritation of nose, throat and airway. INGESTION: May cause
chemical burns in mouth and throat. SKIN CONTACT: Burning pain and severe corrosive skin damage. May cause serious chemical
burns to the skin. EYE CONTACT: Severe irritation, burning and tearing. Prolonged contact causes serious eye and tissue damage.
